انژکتور SL32
Single and manifold injectors are adjustable up to 0.003 cubic inches of discharge per cycle. Each manifold includes two mounting clips and screws (1/4“–20 thread x 1/2” long hex head).
تنظیم
Injector output is controlled by the position of the indicator cap. The location of the cap determines the travel of the discharge piston. When the indicator is fully tightened onto the measuring chamber, lubricant output is decreased to a minimum. Retracting the indicator cap in two full turns permits a maximum of .003 cu. in. to be discharged. Turning the indicator cap beyond two full turns will not increase lubricant output. When the individual injector has been adjusted to the desired output, tighten the locknut against the face of the indicator cap.
Check discharge output from the injector if the cap is adjusted to less than 1/2 turn from the minimum.
Use a clean oil type and viscosity as recommended by the machine manufacturer. Check compatibility with synthetic lubricants.
- پارامتر
پریز: 1-12 پریز
Working pressurel:8.3Mpa-24.1Mpa
Viscosity:000#~2#
discharge:0.016~0.131ml/cyc
Here is more information about the sl32 injectors.
It’s 60-90kgs.
It’s 200kgs-240kgs
It’s up to NIGL #2 grease.
It’s 0.016ml-0.131ml/
It’s the steel with zinc-plate.
It’s the Viton material
It’s NPTF 1/4
It’s NPT1/8.
